Home > 12V LiFePO4 Battery Pack >

12v 150Ah Rechargeable deep Cycle lifepo4 Battery Lithium iron Battery

Product Categories

Guang Zhou Sunland New Energy Technology Co., Ltd.

Trust Seal

Verified Supplier

Credit Check

Supplier Assessment

Contact Now

Add to Cart

Deep Cycle Long Cycle Rechargeable 12V 150AH LifePO4 Battery

About this item:

[Safer Metal Shell Design] Explosion valve and matal steel shell design protect it from fire and explosion. And it has a more stable built-in 120A BMS to protect it from overcharge, over-discharge, charge over-current, discharge over-current, short-circuit, cell voltage self balance, high-temp discharge cut off.
[ 2000+Deep Cycles] 12V150ah LiFePO4 Lithium Battery contains 2000+ deep cycles, each lithium battery can run for more than 10 years, which is 3 times longer cycles than other AGM batteries on the market.And our lithium-iron batteries can maintain 80% capacity after 2000 deep cycles.
[Application] The150Ah LifePO4 Battery has 1920Wh Energy, and can be expanded to 30.7kwh by wired in 4S4P, Perfect for trolling motor, RV, campers, marine, travel trailer, solar power system, motor homes, UPS, off-grid etc.

Deep Cycle Long Cycle Rechargeable 12V 150AH LifePO4 Battery

Battery specifications:

No.	Items	Specifications		Remark
1	Capacity for assembled cell discharging by 0.2C	≥145Ah		Standard discharging method
2	Battery Voltage	12.8-13.2V		Delivery voltage, Within 10 days from Factory
3	Standard charge condition	Charge with 0.2C constant current and 14.6Vconstant voltage, charge to 14.6V continue charging till current decline to ≤0.01C		Charge voltage: 14.6V±0.02V Charge current:0.2C
4	Maximum charge current		100A	For continuous charging mod
5	Maximum discharge current		100A	For continuous discharge mod
6	Standard discharging method	0.2C constant current discharge to 8V,
7	Internal Impedance	Assemblage Impedance		Measure two sides of the drawing line after assembling. .
8	Net	15.5Kg

Safty performance:

No.	Items	Test Method and Condition	Criteria
1	Thermal exposure test	Each fully charged cell, stabilized at room temperature, is placed in a circulating air-convection oven. The oven temperature is raised at a rate of 5 °C/min ± 2 °C/min to a temperature of 130 °C ± 2 °C. The cell remains at this temperature for 10 min before the test is discontinued.	No fire, No explosion
2	Low pressure	Each fully charged cell is placed in a vacuum chamber, in an ambient temperature of 20~25℃. Once the chamber has been sealed, its internal pressure is gradually reduced to a pressure equal to or less than 11.6 kPa (this simulates an altitude of 15240 m) held at that value for 6 h.	No leakage, No fire, No explosion
3.	Short test	The fully charged battery is to be short-circuited by connecting the positive and negative terminals of the battery with resistance load not exceed 100mΩ. Tests are to be conducted at room temperature 20~25℃.	No fire, No explosion The Temperature of the Battery surface not exceeded than 150℃
4	Over Discharg	(After standard charge. Cells are discharged at constant Current of 0.2C to 2.0V, and the positive and negative terminal is connected by a 30Ω wire for 24 hours. Cell Condition: Fresh, Fully charged cell.)	No fire, No explosion
5	Over charge test	After standard charge, continue to charge with a constant voltage 4.8V per a cell, holding 8h.	No leakage, No fire, No explosion
6	Soak Test	Put the batteries into clean water, be soaked for 24 hours.	No break, No fire

Product Tags:

Inquiry Cart 0

Send your message to this supplier


*From:	Your email address is incorrect!
*To:	Guang Zhou Sunland New Energy Technology Co., Ltd.
*Subject:	Subject is empty!
*Message:	For the best results, we recommend including the following details: -Self introduction -Required specifications -Inquire about price/MOQ Characters Remaining: (0/3000) Please enter 20 to 3000 characters to contact this supplier!

Explore more 12V LiFePO4 Battery Pack products from this supplier

Find Similar Products By Category:

Electronic Components & Supplies

Hot Searches: